Create feather shapes in resin, metal clay, and polymer clay. Ideal to make matching jewellery sets of earrings, pendants, and rings. Use the long feather shapes to create wrap around rings and two smaller for earrings and pendants.
To use with resin:
Generally, resin shouldn't stick to these smooth silicone moulds, however mould release can still be used if preferred. To prevent mould shock, the mould can be pre-warmed before use.
Can be used with all resins we stock, including UV curing resins.
To use with metal clay:
Fill the mould with wet clay, ensure the clay is pushed in all the way down into the shape. The mould is transparent so it makes it easy to check, simply turn it over and ensure it is completely filled and there are no air bubbles. Leave to dry in the mould. Be patient with the drying! It takes longer than you think to dry in the mould as the heat only gets in from the top. If you try to pull them out too soon, you'll wreck or distort the shape. We recommend drying for over 24 hours in a warm dry room. You can speed it up by putting the mould in a dehydrator or toaster oven (keep the temperature under 90C).
Size of mould: 77 x 44 x 6mm
- The two feathers are 3.3 cm (1.5") long. Approx. 1.2 cm (1/2") wide at widest part
- Thinnest ring band is 7.4 cm (3") long, 0.5 cm (3/16") wide
- Thickest ring band is 7.2 cm (2 3/4") long, 1 cm (3/8") wide
